RACK MOUNTED
STUDIO SUITE
Modular rack housing builder · no audio effects installed
RMS ROUTING CONSOLE · V1
Connect an output port to an input port by dragging, or tap an output then an input. Connected sockets glow green. Toggle Show Cables to reveal the wiring. This first version supports one channel through the shared FX rack.
AUDIO INTERFACE · SETUP & CALIBRATION
Connect an audio interface, select its input device, identify active physical ports and route each port to a mixer channel. Use headphones and start with low monitor volume.
For a measured round-trip delay, route the interface's low-level output back into a spare input with a suitable cable. Disconnect loudspeakers; never connect an amplified speaker output. Keep output gain low. Acoustic microphone tests include speaker-to-mic travel time.
Calibration has not been run. The measured loopback delay includes output and input buffering; it is not automatically the recording offset.
No interface connected. Live monitoring is off until you start audio.
Detection identifies signal activity; port ordering depends on your browser and interface driver. Verify each port using a sound check. Audio routing needs a desktop browser with microphone permission.
RMS AUDIO EFFECTS · TEST BENCH
Select a local audio file, then start playback. No audio is uploaded.
Audio inactive
Latency and output peaks will appear during playback. Accurate CPU, memory, and audio dropout metrics require further engine instrumentation.
MOUNTING POSITION
Select a rack position. The housing is intentionally empty.
Hold and release a bay for its menu. Hold and drag an installed module to move it.
Only inert blank module faceplates are available. Audio effects and processing will be added later.